Laser diode module diagnostics
We check reduced power, module condition and electrical parameters. We establish whether the diode is responsible and whether replacement is necessary.
Laser diode replacement and calibration
Laser diode module diagnostics, compatible diode and stack replacement, and optical power measurements. Cooling checks and calibration within the scope supported by the model.
from EUR 220
Starting service price; a new module and calibration scope are quoted individually.
Free diagnostics when you commission repair or maintenance.
Engineer travel is charged separately.
Service scope
Laser diode module and stack replacement
We remove the damaged module, select a compatible diode or stack and check mechanical and electrical connections. Availability of a suitable component is confirmed for the model. We install the new compatible component.
Restoring laser diode module cooling
We check heat dissipation, the thermal interface where present and the coolant circuit for leaks. Operating temperature is checked after repair. Where needed, we renew the thermal interface provided for by the design.
Calibration and output power measurement
We measure actual optical power with an appropriate instrument, compare it with settings and perform adjustments supported by the device. A screen value is not an optical power measurement; restored parameters must be confirmed by measurement. We carry out a verification test after replacement.
When diagnostics are needed
We establish the cause by inspecting the specific device.
Reduced results or output
Reduced hair removal results, no emission or low optical power require diagnostics.
Unstable operation
The module operates irregularly or the device reports errors.
Overheating
Heat dissipation problems may affect diode operation.
Failure following a leak
After overheating or leakage, the module and the cause of damage need examination.
How the repair works
Service request
Describe the symptoms and provide the device model and location.
Diagnostics
We inspect components associated with the symptoms and identify the cause.
Agreement
Before repair, we agree the scope, parts availability and cost.
Repair and checks
We carry out the agreed work and check operation of the repaired components.
Price and terms
Laser diode replacement and calibration
from EUR 220
The final cost is agreed after diagnostics.
Diagnostics with repair or maintenance
EUR 0
Free diagnostics when you commission repair or maintenance.
Engineer travel
Charged separately
From EUR 220 for the initial service. Diode replacement labour is listed at EUR 330. A new module, additional components and calibration scope are quoted individually and are not automatically included in the starting price.
Service price list and termsOur technical approach to repair
Identifying the cause
We check related systems rather than simply replacing the damaged part.
Model-specific assessment
We select compatible components and inspection methods for the device's design.
Clear scope of work
We discuss the faults found and agree the repair before proceeding.
Laser diode module replacement example
Module replacement after liquid ingress — Poznań
Symptom: A damaged laser diode module following liquid ingress.
Cause: An incorrectly seated seal caused a loss of watertightness and liquid ingress into the module.
Result: The module and seal were replaced, restoring the assembly's seal.
Full case study →Related services and reading
Frequently asked questions
Not always. Diagnostics of the module, controls and cooling, and optical output measurement are needed.
No. Selection depends on optical, electrical, mechanical and cooling compatibility. Availability is confirmed individually.
No. This is the starting service price. The price list specifies EUR 330 for diode replacement labour; a new module, additional parts and calibration scope are quoted individually.
No. Actual optical power is checked with an appropriate measuring instrument. A screen setting does not replace measurement.
We perform measurements and adjustments within the scope supported by the model. Calibration feasibility and scope are confirmed before work.
Overheating or a leak can damage the module. Replacement without addressing the cause increases the risk of another failure.
We do not claim restored parameters without measurement. Results are assessed for the specific device after the agreed work.
Diagnostics are free when you order repair or maintenance. Travel is charged separately.
Book a service
Engineer travel is charged separately. +48 790 402 597 · contact@lasertechservice.pl